ExtremeSwitching (VSP/Fabric Engine) - Page 48 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Resolved! MTU size with communication between VOSS and non VOSS switches.

Hi,Hope this isn’t a daft question…..By default the MTU size in VOSS is set to 1950. In the topology we are using at the moment there is a L3 connection between the new VOSS switches and EOS S8’s. This is configured with a single VLAN configured at b...

Resolved! Standard practice for Virtual BMAC and SMLT SyS ID to be the same?

Hi,Recently seen a configuration being deployed that used the same value for both the SMLT Virtual BMAC and the LACP SMLT system ID, of say, 0200:00:41:ff.I have for example used these values. believe these where taken from the configuration guide or...

Resolved! Should I redistribute OSPF into ISIS, if so, how do I do safely?

Hi,Have been told that it is quite routine to redistribute OSPF routes into ISIS and visa versa. In my topology OSPF is used as routes are exchanged with external firewalls.Initially my thoughts where that I just needed to redistribute ISIS into OSPF...

Resolved! VSP OSPF with fabric SPBM/ISIS

Hi,Apologies if this is a simple question.Have a S8 network that is being migrated to VSP’s. The legacy network predominantly uses OSPF.The question I have is with the new network built on SPBM / IS-IS fabric using GRT (IP Shortcuts). That means I wi...

Fabric attach - SMLT with LACP

Hello, I am trying to connect a x460G2 stack to a VSP7400 cluster using this configuration with no luck.While both links are up on both sides communication is not happening.x460G2enable sharing 1:49 grouping 1:49,2:29 algorithm address-based L2 lacp ...

Top Kudoed Authors

User

Count

21

15

10

8

4

GTM-P2G8KFN