ExtremeSwitching (VSP/Fabric Engine) - Page 49 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

VSP4450 Error: IP address does not exist in GRT

VSP4450, version 8.5.1.0. Trying to add a new VRF & loopback as part of my fabric extend configuration. This works fine on VSP5420 running 8.5.1.0 and on a VSP4900 running 8.4.2.1. Maybe some redistribution is needed, but seems odd as the other model...

Resolved! Superseeding a direct route with a static route in VOSS

Hi all.I'm curious about if it's posible to make a static route better than a direct route in VOSS 8.2. In my setting we have a VLAN with the gateway *outside* the switch but with an IP configured in the switch VLAN interface, so there is a local dir...

What type of connector is supported in Extreme SFP module?

Hi, Is there any official recommendation what type of connector I should use in Extreme SFP modules? I suppose I should use LC UPC, but can I use LC APC? I could not find any statement in Extreme documentation but for example Cisco doesn't support LC...

Resolved! NNI as a DCI - Best practice

Does Extreme have any best practices for DCI links configured as NNI's for a pair of 8404's?These NNI's will be be connecting BCB's, So at this point of time they are strictly just transit nodes and are not doing any L3 features for the network, VRRP...

BCB VS BEB

Can a BCB have UNI ports and still work as a BCB?

Top Kudoed Authors

User

Count

34

18

18

18

8

GTM-P2G8KFN