ExtremeSwitching (VSP/Fabric Engine) - Page 69 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

VSP 4900 PSU

Hi,We have an issue with a VSP-7400-48Y-8C where we cannot get a 2nd PSU to physically fit in the bay.The switch was ordered as a 'bundle' and came with 1x XN-ACPWR-750W-F PSU, and we ordered a 2nd XN-ACPWR-750W-F PSU for resilience.We've followed th...

TIP - VRRP with VRRP Backup Master Configuration

If you experience prolonged failover times in a vIST setup with VRRP and VRRP BackupMaster, ensure you configure VRRP holddown timers: Enable VRRP holddown with a timer of 30 seconds. This will limit the traffic loss to 100s of miliseconds as it wil...

Extreme 5520 VOSS 8.4.1.1 - Telnet/SSH/https connection from end device to mgmt vlan IP

Dear all, I’m currently testing the last VOSS 8.4.1.1 version on Extreme 5520 switch. I tried to connect (telnet/ssh/https) to the switch via vlan mgmt interface from my computer (192.168.202.100/24) connected directly on the switch (port 1/24) witho...

Resolved! VOSS inVSN filter to limit bandwidth

I read a post on how to do port rate limiting, but I would like to rate-limit a port based on the inVSN filter. We have a 100M WAN interface where we can enable rate-limiting, but I would like to put a limit on the amount of traffic for each L3VSN. ...

Resolved! SLPP Config

We are trying to implement SLPP into our environment and it doesn’t seem to be behaving as it should.From my understanding after reading some of the best practices in a scenario where an edge switch is connected back to the fabric core (in our case V...

Top Kudoed Authors

User

Count

37

21

21

18

8

GTM-P2G8KFN