Hello All, interface gigabitethernet 1/1 lacp aggregation enable lacp enable lacp key 10 lacp mode passive interface gigabitethernet 1/2 lacp aggregation enable lacp enable lacp key 10 lacp mode passive I think I done the lacp config, but I need t...
Hi, Hoping someone can provide some assistance in understanding SMLT / MLT configuration on a VSP8600. I have a scenario where I’m migrating some EOS cores with VSPs one at a time, and I initially need to support STP to the egde. To do this I ini...
Hi, Appreciate this could be a straight forward question, its for a VSP8600 version 6.3.2.0. The system has been configured using the simplified vist (it was requested) As part of the configuration I need to add VLANs to MLT interfaces like so: m...
Hi, I’m finding the configuration on the VSP8600 very fractured and hard to read, and thereby hard to configure and fault find, on top of that there is no pipe command. Here is an example below…. if I need to configure an interface / port it is ref...
I have a question. I have a 4850GTS-PWR+ switch which says has this log after an electrical storm: show log Type Time Idx Src Message ---- ----------------------------- ---- --- ------- S 00:00:00:00 1...
