Hey teamI am running Forescout as a NAC and when a client via Dot1x gets access to the network and Forescoute sends a CoA message i se the switch accept it but its no kicking out the client until i remove the cable and put it back in. Sometimes mulit...
I was able to get the virtual-ist up and running in the GNS3 environment using the new 9.2 image. Oh I was so happy. But, alas it stops working after a couple of minutes. If we reset the switch it comes up and then a couple of minutes later it goes d...
We have pairs of N7K and N9k connecting via eigrp (full mesh), each one of the pair connected to two mpls routers, each pair have routing table, I am looking to replace the routed interfaces between pairs of N7K and N9K with vPC, is that possiable ? ...
Hi everybody,Today, a post with an odd problem. Few weeks ago, I was faced with 3 contiguous ethernet ports on a 5420M-48W-4YE switch which won't come up whereas PoE was delivering power. Admin state was up, but nothing. Making a test directly with a...
Is there a possibility to get on a Fabric an overview of the Fabric Size?With show virtual-ist I can see if the device is working with Virtual ISTshow isis interface shows me a working ISIS Interface. To have an understanding of which ports my Fabric...
