Changing next-hop for a single IP

[JoseG]

Hi all.

We have a pair of hosts in the same VLAN whose  traffic need to be directed to a next-hop different of that in the default route configured in the VSP. As we searched in the forum and diverse documentation it seems that this is only feasible using filters, is that right? We was thinking in a filter like this:

filter acl 1 type inVlan
filter acl vlan 1 10
filter acl ace 1 1
filter acl ace action 1 1 permit redirect-next-hop <next-hop IP>
filter acl ace action 1 1 permit unreachable permit
filter acl ace action 1 1 permit count
filter acl ace ethernet 1 1 ether-type eq ip
filter acl ace ip 1 1 routed-only
filter acl ace ip 1 1 src-ip eq <host IP>
filter acl ace 1 1 enable

Would this do the work? Thanks!

[AngeloD]

ACL is correct but remove “routed-only” if switch handle traffic only at L2 level (don’t perform routing on 110 VLAN).

The switch will report a warning but I confirm, redirection at L2 still works on release 9.1.0.0 and 9.2.0.0

[RobertD1]

This looks very similar to the article on using PBR (Policy Based Routing) on VOSS. The filter should be able to redirect your traffic to a different destination in theory.

https://extreme-networks.my.site.com/ExtrArticleDetail?an=000082909