06-22-2021 08:33 PM
Hi all,
with the newer Wifi 6 APs (305C,410C,510C) i would like to know if i can check with a CLI command the reason why an AP status led is blinking. I know they do that if there is a PoE issue but I had cases were they stopped blinking after i placed them on the map and send a Delta update.
My question: Can i check by command what the status of the LED light is (stable/blinking and the reason why)?
Best,
Andi
Solved! Go to Solution.
06-23-2021 12:57 PM
Hello Andi,
Please try cli command: #show system led
Example:
AP305C-Internal-Mesh#show system led
Brightness configuration: bright
System LED status:
No Led Colour Blinking
---------------------------------------------------------
1 Power Off No blinking
2 Status White No blinking
You can refer to the AP manual for details on LED status for example:
The following is an excerpt from the AP305C/AP305CX manual:
Thank you,
a month ago
Any reason an AP410C-1 would blink red? White, then amber, then red, then dark.