NAC Manager - VR-Router Name cannot be editing
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-05-2016 01:31 PM
i want that NAC Manager (Netsight) configure the RADIUS on my EXOS Switches (X450-G2 V16.1.3.6-Patch-1-7). But i cannot change to Virtual Router Field to VR-Default - i get only the error below:
if i use vr-Mgmt it will be accepted - but this is wrong.
Does anybody know this error message ?
What needs to be changed that VR-default will be allowed ?
if i use vr-Mgmt it will be accepted - but this is wrong.
Does anybody know this error message ?
What needs to be changed that VR-default will be allowed ?
7 REPLIES 7
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-06-2016 06:06 AM
Case Number: 01242213
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-06-2016 05:21 AM
Hello Matthias, maybe because it already has a config but I think there might be something wrong in NAC. I think you should log a case so this can be handled properly and fixed if it is a bug.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-06-2016 05:08 AM
Hi Oscar,
could it be that this error occur if the switch have already a radius config ?!
i ecpect that if i define the value this will overrite the already configured settings.
Regards
could it be that this error occur if the switch have already a radius config ?!
i ecpect that if i define the value this will overrite the already configured settings.
Regards
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-06-2016 05:04 AM
Hi Oscar,
it seems that there is a sleeping bug in the software. i use Netsight V6.3.0.179.
I delete the switch and reenter then i got a little different message:
i think i open a case to clarify...
it seems that there is a sleeping bug in the software. i use Netsight V6.3.0.179.
I delete the switch and reenter then i got a little different message:
i think i open a case to clarify...
