WS-AP3705i Console Port

[kouichi_ohtomo]

We want to use AP3705i console port.
Can we configuration from console port of AP3705i? (IP, gateway, etc.)
to tell us ;
AP console port pin assignment , terminal setting

Regards,

[juan_romero]

Thank you very much, I'll try the command.

[juan_romero]

Is there a way to confirm configuraration a "show configuration" command or something like that?

[Ronald_Dvorak]

Hi, you'd set the following parameter via the console port to allow the AP to connect to the controller if you don't use an DHCP server...
- IP = cset ipaddr x.x.x.x
- subnetmask = cset ipmask x.x.x.x
- gateway = cset gateway x.x.x.x
- set controller IP = cset authip 1 x.x.x.x
to apply and save use..
- capply
- csave

The baudrate is 115200 - just use a the same console cable as you'd use for a router/switch.

[kouichi_ohtomo]

Thank you for reply.

We were able to confirm that it can be set from the console port.

However, there was the discovery of 2 points.

1, console cable, in the Cisco console, was not a Enterasys console.
2, It was required first to [cset dhcpc disable] command

** We have tested with firmware version "08.32.08.0002".

Regards,