WS-AP3705i Console Port
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-06-2015 08:06 AM
We want to use AP3705i console port.
Can we configuration from console port of AP3705i? (IP, gateway, etc.)
to tell us ;
AP console port pin assignment , terminal setting
Regards,
Can we configuration from console port of AP3705i? (IP, gateway, etc.)
to tell us ;
AP console port pin assignment , terminal setting
Regards,
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-18-2016 04:02 PM
Thank you very much, I'll try the command.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-16-2016 06:23 PM
Is there a way to confirm configuraration a "show configuration" command or something like that?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-06-2015 10:21 AM
Hi, you'd set the following parameter via the console port to allow the AP to connect to the controller if you don't use an DHCP server...
- IP = cset ipaddr x.x.x.x
- subnetmask = cset ipmask x.x.x.x
- gateway = cset gateway x.x.x.x
- set controller IP = cset authip 1 x.x.x.x
to apply and save use..
- capply
- csave
The baudrate is 115200 - just use a the same console cable as you'd use for a router/switch.
- IP = cset ipaddr x.x.x.x
- subnetmask = cset ipmask x.x.x.x
- gateway = cset gateway x.x.x.x
- set controller IP = cset authip 1 x.x.x.x
to apply and save use..
- capply
- csave
The baudrate is 115200 - just use a the same console cable as you'd use for a router/switch.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-06-2015 10:21 AM
Thank you for reply.
We were able to confirm that it can be set from the console port.
However, there was the discovery of 2 points.
1, console cable, in the Cisco console, was not a Enterasys console.
2, It was required first to [cset dhcpc disable] command
** We have tested with firmware version "08.32.08.0002".
Regards,
We were able to confirm that it can be set from the console port.
However, there was the discovery of 2 points.
1, console cable, in the Cisco console, was not a Enterasys console.
2, It was required first to [cset dhcpc disable] command
** We have tested with firmware version "08.32.08.0002".
Regards,
