Ap2660 Login issues, default password not working
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-29-2018 06:13 PM
I have many legacy ap2660 devices, and they are set to get a dhcp address, then we hard code the wireless controller (via telnet). I have found that many of these devices do not let me log into them with the default admin / new2day credentials. We have not changed the password, and I have held the red reset button down for about 30 seconds. Even after that I still cannot log in. Are there other credentials that I can use to log in, or is there another way to connect to these to perform administration tasks?
Thanks,
Dave
Thanks,
Dave
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-29-2018 06:30 PM
Great thanks!!!!
Is there a way to mark this answered / solved?
Is there a way to mark this answered / solved?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-29-2018 06:30 PM
All set and marked.
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-29-2018 06:18 PM
Hello David the default password for the 2600 series AP's was admin with e~=2.718 as the password
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-29-2018 06:17 PM
You could also try using the following: Username: admin / Password: e~=2.718