default role not working
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-10-2016 12:51 PM
in WLAN Service, the default authenticated role does not take effect , any one noticed the same?
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-16-2016 07:30 AM
the default role for authenticated is not taking effect .
only when i respond with filter -id the roles will get applied, but if filter-id is not in the response the authenticated and non-authenticated users gets the same role (quarantine) , although this should change to Allow_All role after authentication.
only when i respond with filter -id the roles will get applied, but if filter-id is not in the response the authenticated and non-authenticated users gets the same role (quarantine) , although this should change to Allow_All role after authentication.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-12-2016 11:56 AM
is that a question ?
you might want to explain in more detail steps what is going on.
i.e. my plan is that if client#A connects to SSID#B with 802,1X setting #C that role#Y is choosen but instead I get role#Z
As Doug mentioned it's working fine - pretty sure that this is a configuration error.
you might want to explain in more detail steps what is going on.
i.e. my plan is that if client#A connects to SSID#B with 802,1X setting #C that role#Y is choosen but instead I get role#Z
As Doug mentioned it's working fine - pretty sure that this is a configuration error.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-12-2016 01:55 AM
802.1x , the radius server responds with vlan id , but no filter-id , once authenticated and put in correct vlan users should be allowed all.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-10-2016 12:57 PM
Seems to be working fine in my lab. I would need to understand your setup better. I would suggest contacting the GTAC.
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks