IdentiFi SNMP AP status
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-25-2018 01:43 PM
Hello, all!
Does any body help with OID for monitoring UP/DOWN status of Access Point?
Thank you!
Does any body help with OID for monitoring UP/DOWN status of Access Point?
Thank you!
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-25-2018 05:02 PM
Thank you for information!!!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-25-2018 04:50 PM
Just unplug one AP and the message that you rx on the NMS is the down one 🙂
Or check out the following old post - in my comment at the end is a link to a pdf with some information about the AP down traps.
https://community.extremenetworks.com/extreme/topics/how_can_we_send_an_email_from_controller_when_a......
Or check out the following old post - in my comment at the end is a link to a pdf with some information about the AP down traps.
https://community.extremenetworks.com/extreme/topics/how_can_we_send_an_email_from_controller_when_a......
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-25-2018 04:35 PM
There is third-party NMS.
Customer want to monitor APs status by SNMP.
APs 3805 and will be 3825 in feature.
Thank you!
Customer want to monitor APs status by SNMP.
APs 3805 and will be 3825 in feature.
Thank you!
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎06-25-2018 04:31 PM
Hello,
SNMP is usually used for more specific information. You might be able to get a basic up/down if you are querying a controller, but i'm not certain. Are you trying to query a controller or the AP directly? Which controller/ap model?
SNMP is usually used for more specific information. You might be able to get a basic up/down if you are querying a controller, but i'm not certain. Are you trying to query a controller or the AP directly? Which controller/ap model?