No station connects to my different SSIDs anymore

[Peter_Kulmbrein]

No Client is able to connect to my different SSIDs anymore. Configuration is 2 V2110 on 10.31.05 in a FFO config - both up and running showing everything green and nothing in the log.
APs are 3805 connected and showing green - SSH possible and able to ping the Controller;

physical interface in a dedicated vlan with the APs w/o default Gateway

what i already tried i setting up a new Open SSID - but clients wont even connect to that open SSID.

no station event shown and when i wireshark on the AP i get an "Status code: The authentication has been declined (0x0025)" answer.

Anyone had that issue and knows how to solve it or knows anything about that behaviour?

Didn't have that before...

regards
Peter

[Umut_Aydin]

Hi,

does your client get IP addresses at all?
Promiscous mode enabled?
Can you ping the topology interfaces?

Do you use VMware?
Does it work before or is this a new setup? I assume yes.
Did you made any change on VMware/upgrade etc.?

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-configure-vSwitch-properties-For-V2...

Does it work if you reboot the AP?

Regards

Umut Aydin

[Peter_Kulmbrein]

As you can see above Ron guided me in the right direction - so I was able to solve the problem 😉

BR
Peter

[Jacob__Praveen]

Peter,

Do you still have the issues reported previously?

[Peter_Kulmbrein]

Hi Umut,

- IP Adress allocation does take place after connecting to the SSID i think
- i'll check for the promiscous mode Setting and i can ping the topo if
using VMware - paravirtual already selected if u mean that 😉
- we upgraded to 10.31.04 from 10.31.01 but downgrading didn't help
- no changes were made to the VMware enviroment

- am going to reboot all aps tomorrow

br
Peter