Unable to configure 10 SSIDs on V2110+Hyper-V

[Ilya_Semenov]

Hello, everybody!

I have V2110 (9.21) with Hyper-V (2012 R2) installation. My task is to configure 10 different SSIDs for 10 teams, and every SSID have to be binded to a certain VLAN.

SSID (Team-1) have to be associated to VLAN10, SSID (Team-2) have to be associated to VLAN20, etc.

Could you please tell me, what kind of topologies I have to create in this case?

At the moment I have the following:

For each SSID I've created two topologies, for example:

VLAN10, B@EWC, VLANID 10, untag, port esa1, 192.168.10.1
VLAN10-S, B@AP, VLANID 10, tagged

It works only if on Hyper-V side I set "VLAN identification" for a certain interface. This limits me to creating only 2 SSID working simultaneously because of untagged traffic at V2110 side and Hyper-V limitations (where I can set only 1 VLAN per interface).

Please, help me to solve the problem!

Many thanks in advance.

[Doug]

Please reference: https://gtacknowledge.extremenetworks.com/articles/Solution/Hyper-V-fails-to-pass-VLAN-tags-on-a-bri...

[Ilya_Semenov]

Hello, Ron!

The required infrastructure works only if both topologies are configured and enabled.

Would you please share this manual with me?)

Thank you.

[Drew_C]

I believe the document Ron is referring to can be found on this page: https://extranet.extremenetworks.com/downloads/Pages/WirelessControllers.aspx
Look on the documentation page under Wireless Hardware and Gateway Guides -> Virtual Gateway V2110

[Ronald_Dvorak]

Regarding the screenshot - you either configure a bridge@EWC OR bridge@AP but not both.
As I've mentioned it comes down to the network design which method to use.

I'd recommend to read the manual "V2110 Virtual Appliance Installation Guide - MS Hyper-V Platform" page#13, there are the instructions to support tagged VLANs in Hyper-V which you need for bridge@EWC toplogies.

If you use bridge@AP the controller can't be the DHCP server - you'd need an external one.

-Ron