Where can I find DHCP lease information on IdentiFi v10.11?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-03-2016 01:45 PM
With dhcp enabled on identifi V2110 controller running 10.11 code, where do i see the details of lease info?
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-25-2016 03:54 AM
Thanks. Later found this also https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-delete-the-DHCP-lease-file-on-the-I... basically it is possible to go to the shell level and edit the leases file. I would add to the How To that the default writing cycle of the dhcp daemon to this lease file is 5 minutes, and it is best to start editing after the next write is done so one gets full 5 minutes editing time.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-24-2016 02:08 PM
Very good Thanks Ron
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-24-2016 01:13 PM
You can't clear the leases via the GUI.
But you'd set the topology to "use relay" and any IP and save - then set it back to "local DHCP" - that should reset/clear the lease file.
But you'd set the topology to "use relay" and any IP and save - then set it back to "local DHCP" - that should reset/clear the lease file.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-21-2016 11:56 AM
how to clear leases in identifi (9.21.6 in my case)? ran out of leases, reduced lease time, but the now obsolete leases are not automatically cleared.
