hi, community.
I deploied 4 ap230s at home, 3 of them are almost the same, the last one is a little difference. this one will be utilize as a simple layer2 switch.
- eth0 as trunk link to a management switch, which has been config as a trunk port, allow vlan all, native vlanid is 9.
- eth1 as access link to a computer.
- mgt0 which is a virtual port bind to eth0 or eth1?
here is my ap’s interface info:
AH230-living#show interface eth0
Parent interface=none;
Mode=backhaul; Mac learning= disabled; Admin state=enabled;
WEB server=disable; NAT support=disable; DHCP client=disable; DHCP server=disable; DNS server=disable;
IP addr=0.0.0.0; Netmask=0.0.0.0;
Internal station traffic state=enabled;
Operational state=up; Duplex=full-duplex; Speed=1000Mbps;
LLDP state=enabled; CDP state=enabled;
Hiveid="hkxd"; Native-vlan=1;
MAC addr=d854:a2a0:58c0; MTU=1500;
Rx packets=846327; errors=0; dropped=0;
Tx packets=394283; errors=0; dropped=0;
Rx bytes=459177810 (437.906 MB); Tx bytes=37309047 (35.581 MB);
AH230-living#show interface eth1
Parent interface=none;
Mode=backhaul; Mac learning= disabled; Admin state=enabled;
WEB server=disable; NAT support=disable; DHCP client=disable; DHCP server=disable; DNS server=disable;
IP addr=0.0.0.0; Netmask=0.0.0.0;
Internal station traffic state=enabled;
Operational state=down; Duplex=unknow; Speed=unknow;
LLDP state=enabled; CDP state=enabled;
Hiveid="hkxd"; Native-vlan=1;
MAC addr=d854:a2a0:58c1; MTU=1500;
Rx packets=0; errors=0; dropped=0;
Tx packets=5; errors=0; dropped=0;
Rx bytes=0 (0 B); Tx bytes=1137 (1.110 KB);
AH230-living#show interface mgt0
Admin state=enabled; Operational state=up;
DHCP client=disabled;
Default IP subnet=192.168.0.0/255.255.0.0;
IP addr=192.168.9.154; Netmask=255.255.255.0; Default Gateway:192.168.9.254;
VLAN id=1; Native vlan id=1;
MAC addr=d854:a2a0:58c0; MTU=1500;
Rx packets=103793; errors=0; dropped=0;
Tx packets= 50926; errors=0; dropped=0;
Rx bytes=11338060 (10.813 MB); Tx bytes=6101342 (5.819 MB);
I am confused of port type configuration. how to config them under xiq correctly?
do I have to create a new device template, clone a new port type template, edit it to suite my need, after that, combine them together. finally assign the new device template to this special ap230. could I just edit this specific ap230’s port type individually?
