AP-7522 Client Bridging Isn't Working - March 2019

[Aaron_Wright]

I've posted about this problem before and I'm having the same problem that I can't solve.

https://community.extremenetworks.com/extremewireless-wing-230514/ap-7522-client-bridging-isn-t-work...

I've upgraded both APs to 5.9.3

I have set up AP1 with ssid myWireless

I have configured AP2 with the following

• en
• config t
• rf-domain default
• country-code us
• exit
• profile ap7522 default-ap7522
• interface radio 1
• shut
• interface radio 2
• rf-mode bridge
• bridge ssid myWireless
• bridge encryption-type ccmp
• bridge authentication-type none
• bridge wpa-wpa2 psk 0 myWirelessKey
• comm wr
• self
• interface vlan 1
• ip address 192.168.1.82/24
• exit
• ip default-gateway 192.168.1.1
• commit write

When I run "show wireless bridge candidate-ap" it shows "Total number of candidates displayed: 0"

Can anyone help me get this bridging configuration working?

Thank you

[Aaron_Wright]

I may have resolved this by enabling 5GHz on one of the antennas on AP1

[Aaron_Wright]

The APs are sitting right next to each other. AP1 is connected to the network with an Ethernet cable. AP2 is not connected with an Ethernet cable, I am configuring it through the console port.

[Aaron_Wright]

I have 2 antennas installed on both access points

I have verified that I can successfully connect to AP1 with my laptop and ping other devices on the 192.168.1.0/24 network