Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-05-2019 08:15 AM
Hi,
I have two AP-7532i and one of them is not working as it should. When I restart it (via PoE) it just light a some blinks (amber) and then it stops blinking and it is like dead. Does this mean that it has PoE problem? Any help would be appreciated!
Br
I have two AP-7532i and one of them is not working as it should. When I restart it (via PoE) it just light a some blinks (amber) and then it stops blinking and it is like dead. Does this mean that it has PoE problem? Any help would be appreciated!
Br
Solved! Go to Solution.
1 ACCEPTED SOLUTION
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-05-2019 12:34 PM
Hello Artman,
Since you said that one of the APs is working, I would recommend you unplug this one and use the same cable/POE setup to test the non-working one. The AP should fully boot up and you should see both (green and amber) lights once done. If using known working POE/Cable and you still see no lights, are unable to reach the AP via console or SSH and it does not look like it's even powered up, then you might want to consider RMAing it.
Thank you,
Chris
Since you said that one of the APs is working, I would recommend you unplug this one and use the same cable/POE setup to test the non-working one. The AP should fully boot up and you should see both (green and amber) lights once done. If using known working POE/Cable and you still see no lights, are unable to reach the AP via console or SSH and it does not look like it's even powered up, then you might want to consider RMAing it.
Thank you,
Chris
Christoph S.
6 REPLIES 6
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-05-2019 08:19 AM
I have tried to do that but it doesn't work! I have tried with different speed (19200, 115200 but it is not working). Do you know other speed that I can be use? And if it is not working to ssh into the AP does it mean that it has not power on it?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-05-2019 08:17 AM
Hi Artman,
Did you try to connect through the console port and see if there is any messages during the bootup?
Did you try to connect through the console port and see if there is any messages during the bootup?
