AP410 Radio 3 sensor

[adf10]

Hello Community,

I have a group of AP410i deployed on an office building, with Radio1 configured on 2.4Gz , Radio2 on 5Ghz and Radio3 enabled and configured as sensor. 

Some APs reports Radio3 in State OFF like this:

But some of the APs reports Radio3 as State Sensor (Active) like this

All AP are configured with the same profile , how should I configure them to all have the State as Sensor and not OFF.

Thank you in advance for your help and prompt reply.

Alex

[RobertZ]

We would need to see the config of the WLC, but maybe you enabled the smart sensor feature which will turn on some sensors and not others. ( Check the smart-rf-policy ) 

[adf10]

Hello Robert,

Thank you for your help. 

Here is my smart-rf-policy configuration:

smart-rf-policy default
assignable-power 5GHz max 20
assignable-power 5GHz min 10
assignable-power 2.4GHz max 20
assignable-power 2.4GHz min 10
channel-list 5GHz 36,40,44,52,56,60,64,100,104,108,112,116,120,124,128,132,136,140,149,153,157,161,165
no select-shutdown
no smart-sensor
smart-sensor auto-trigger
smart-sensor band smart-band-5GHz
smart-sensor tri-radio-only

I have no analytics installed on this controller but I understood that having the sensors enabled could help.

I would really appreciate if you have a guide for best practices configuring this sensors (when you don't have ADSP installed) or any other information on this regard.

Thank you,

-Alex