AP8533 and 802.3at not working

[Maciek]

Hi,
i got problem with AP8533 and proper PoE powering. I got HP Procurve 2920 PoE+ switch and connected AP8533 but when i check details of this AP there is information that used standard is 802.3af.
There is no additional configuration on switch - default configuration on interfaces.

Below are power details from interface 1 switch:

Status and Counters - Port Power Status for port 1

Power Enable : Yes
LLDP Detect : enabled
Priority : low Configured Type :
AllocateBy : usage Value : 17 W
Power Class : 4 Detection Status : Delivering

Over Current Cnt : 0 MPS Absent Cnt : 0
Power Denied Cnt : 0 Short Cnt : 0

Voltage : 56.1 V Current : 187 mA
Power : 25.5 W Pre-std Detect : off

[ckelly]

Confirm that LLDP enabled on the AP8533.

[Maciek]

and below is last few lines from detailed AP info:
Power management information for ap8533:
Power management Mode : Auto
Power management status : 3af
Ethernet power status : all up
Radio power status : all up

[Maciek]

Yes, LLDP is enabled.

lldp power negotiation: yes
PSE Type 2: yes
PSE power granted: 255
PD power requsted: 255

[ckelly]

This appears to be LLDP configurations from the switch.

LLDP needs to also be confirmed as being enabled on the AP.

Go into the AP8533 Profile and then info the ge1 interface section.

# show context include-factory |in lldp

It should be enabled by default, but need to first confirm.

[Maciek]

Yes. It's enabled:

lldp receive
lldp transmit