checking ip AP

[error404]

can you check any ap the ip connected to the controller in some way?

[RobertZ]

Are your APs adopted at all? Run the below CLI command to see if there is a adoption issue:

show adoption status

[error404]

dont work

[error404]

VX9000#show wireless ap
------------------------------------------------------------------------------------------------------------------------------------------------------------
MODE : radio modes - W = WLAN, S=Sensor, ' ' (Space) = radio not present
------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------------------------
AP-NAME AP-LOCATION RF-DOMAIN AP-MAC #RADIOS MODE #CLIENT IPv4 IPv6
------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------------------------
Total number of APs displayed: 0
VX9000#

[RobertZ]

Also try the following CLI command:

sh ip int brief on < DEVICE-NAME AP/Controller name>

[Christoph_S]

CLI command:

#show wireless AP

Please let me know if this is what you are looking for.