cancel
Showing results for 
Search instead for 
Did you mean: 

checking ip AP

checking ip AP

error404
New Contributor
can you check any ap the ip connected to the controller in some way?
9 REPLIES 9

RobertZ
Extreme Employee
Are your APs adopted at all? Run the below CLI command to see if there is a adoption issue:

show adoption status

error404
New Contributor
dont work

error404
New Contributor
VX9000#show wireless ap
------------------------------------------------------------------------------------------------------------------------------------------------------------
MODE : radio modes - W = WLAN, S=Sensor, ' ' (Space) = radio not present
------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------------------------
AP-NAME AP-LOCATION RF-DOMAIN AP-MAC #RADIOS MODE #CLIENT IPv4 IPv6
------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------------------------
Total number of APs displayed: 0
VX9000#

RobertZ
Extreme Employee
Also try the following CLI command:

sh ip int brief on < DEVICE-NAME AP/Controller name>

Christoph_S
Extreme Employee
CLI command:

#show wireless AP

Please let me know if this is what you are looking for.
Christoph S.
GTM-P2G8KFN