cancel
Showing results for 
Search instead for 
Did you mean: 

CLI Command to reboot both NX5500 cluster 5.9.2

CLI Command to reboot both NX5500 cluster 5.9.2

OGB-NIKO
Contributor

Does anyone know the CLI Command or step to reboot both NX5500 cluster version 5.9.2 gracefully

1 ACCEPTED SOLUTION

Christoph_S
Extreme Employee

When you type #reload, you will be prompted to confirm the action. Type Y and the controller will reload. If the cluster is properly configured, all APs should fail over to the Standby controller. Once the Primary controller is back up, run the same command on the Standby controller and all APs should come back to the Primary controller while the Standby reboots. 

 

Thank you,

Christoph S.

View solution in original post

6 REPLIES 6

OGB-NIKO
Contributor

Excellent thank you Chris

Christoph_S
Extreme Employee

When you type #reload, you will be prompted to confirm the action. Type Y and the controller will reload. If the cluster is properly configured, all APs should fail over to the Standby controller. Once the Primary controller is back up, run the same command on the Standby controller and all APs should come back to the Primary controller while the Standby reboots. 

 

Thank you,

Christoph S.

OGB-NIKO
Contributor

So i just type the reload command and enter and then follow the rest of the steps above ?

Christoph_S
Extreme Employee

Yes, start by rebooting the Primary controller, all APs should fail over to the Standby controller. Once the Primary is back up, reboot the Standby controller and all APs should revert back to the Primary controller. 

 

I hope this helps,

Christoph S.
GTM-P2G8KFN