CLI Command to reboot both NX5500 cluster 5.9.2

[OGB-NIKO]

Does anyone know the CLI Command or step to reboot both NX5500 cluster version 5.9.2 gracefully

[OGB-NIKO]

Excellent thank you Chris

[Christoph_S · Accepted solution]

When you type #reload, you will be prompted to confirm the action. Type Y and the controller will reload. If the cluster is properly configured, all APs should fail over to the Standby controller. Once the Primary controller is back up, run the same command on the Standby controller and all APs should come back to the Primary controller while the Standby reboots. 

Thank you,

[OGB-NIKO]

So i just type the reload command and enter and then follow the rest of the steps above ?

[Christoph_S]

Yes, start by rebooting the Primary controller, all APs should fail over to the Standby controller. Once the Primary is back up, reboot the Standby controller and all APs should revert back to the Primary controller. 

I hope this helps,