controller assisted mobility will help ?

[Aviv_Kedem]

We have in some warehouse, is divided with 2 ip segments.We have here only unmanaged switches, with 20 pices of AP6532 and 20-25 wireless clients.
We need to make wireless clients to roam between 2 ip segments.
If we configure VC with controller assisted mobility + layer3 adoption, it will make the roaming work?
Or just only way is buy NX/VX for tunneling WLAN traffic to controller ?
Thanks

[Aviv_Kedem]

So if I understanding right, if we had 2 vlans on ge1 of AP's, wlan with vlan pool, layer3 adoption with VC - assisted mobility was work with local bridging?
Thanks

[Daren_Ellis]

Hi Aviv,

To use controller assisted mobility you will need to tunnel traffic back to the controller and the Virtual controller does not support tunneling.
You will need to ensure you purchase a controller that supports tunneled traffic if you want to use controller assisted mobility.

Please see related article below.
https://gtacknowledge.extremenetworks.com/articles/Solution/Laptop-MU-Roaming-issue-Between-RF-Domai...

Additional note:
The VX does not support tunneling

Kind Regards
Daren

[Daren_Ellis]

Yes,
VX does not support tunneling.
Please be advised that even if it is working in your environment, it is not a supported configuration on the VX platform.
As you noted it does not have a dataplane.

[Aviv_Kedem]

I was sure tunneling with VX is working but not recommended since is not have a dataplane .
Are you sure?

[Aviv_Kedem]

Wow,

The VX does not support tunneling

Thanks