cancel
Showing results for 
Search instead for 
Did you mean: 

DVC with internal RADIUS

DVC with internal RADIUS

Alexandr_P
Valued Contributor
Hello!

APs - AP310i with VC with internal RADIUS.
Redundancy working fine - after failure control is normally transferred to the backup controller.
But after re-election of the controller, the RADIUS server policy activation checkbox is reset (Activate RADIUS Server Policy).
As a consequence, there is a problem with authentication using 802.1x
After checking the checkbox and saving the config, everything works again.
WZam8oXkRt650MX9wbfJ_123.png
Any ideas how to resolve this issue?

Thank you!
1 REPLY 1

Ovais_Qayyum
Extreme Employee
Hi,
I would suggest that you check the "Radius Server Policy" is applied on the AP310i System Profile and not the VC AP directly which will make it a device config limited only to that AP.

Regards,
Ovais
GTM-P2G8KFN