Extreme Wing AP VC and Physical IP configuration
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-26-2019 09:49 AM
Dear Support
Good Day. I have 18 units of Wing7630 and configure as Dynamic VC.
my question is all the AP I had configure IP address at Interface VLAN. when the AP is up why all the AP will go to the same IP address.
show run
!
! Configuration of AP7632 version 5.9.2.5-001R
!
!
version 2.6
!
!
client-identity-group default
load default-fingerprints
!
ip access-list BROADCAST-MULTICAST-CONTROL
permit tcp any any rule-precedence 10 rule-description "permit all TCP traffic"
permit udp any eq 67 any eq dhcpc rule-precedence 11 rule-description "permit DHCP replies"
deny udp any range 137 138 any range 137 138 rule-precedence 20 rule-description "deny windows netbios"
deny ip any 224.0.0.0/4 rule-precedence 21 rule-description "deny IP multicast"
deny ip any host 255.255.255.255 rule-precedence 22 rule-description "deny IP local broadcast"
permit ip any any rule-precedence 100 rule-description "permit all IP traffic"
!
mac access-list PERMIT-ARP-AND-IPv4
permit any any type ip rule-precedence 10 rule-description "permit all IPv4 tra--More-- ffic"
permit any any type arp rule-precedence 20 rule-description "permit all ARP traffic"
!
ip snmp-access-list default
permit any
!
firewall-policy default
no ip dos tcp-sequence-past-window
no stateful-packet-inspection-l2
ip tcp adjust-mss 1400
!
!
mint-policy global-default
!
meshpoint-qos-policy default
!
wlan-qos-policy default
qos trust dscp
qos trust wmm
!
radio-qos-policy default
!
--More-- wlan "Staff WiFi"
description Staff WiFi
ssid Staff_SJIS
vlan 30
bridging-mode local
encryption-type ccmp
authentication-type none
wpa-wpa2 psk 0 St@ff12345
!
wlan "Student WiFi"
description Student WiFi
ssid Student_SJIS
vlan 40
bridging-mode local
encryption-type ccmp
authentication-type none
wpa-wpa2 psk 0 1234567890
!
!
management-policy default
telnet
no http server
https server
--More-- rest-server
no ftp
ssh
user admin password 1 a2f002244f271fe5f29c8b864f62d644073f7c91938c21b0b2964e47293e4892 role superuser access all
snmp-server community 0 private rw
snmp-server community 0 public ro
snmp-server user snmptrap v3 encrypted des auth md5 0 admin123
snmp-server user snmpmanager v3 encrypted des auth md5 0 admin123
!
event-system-policy default
!
nsight-policy default
!
profile ap7632 default-ap7632
ip name-server 8.8.8.8
ip name-server 8.8.4.4
ip default-gateway 172.16.10.254
autoinstall configuration
autoinstall firmware
crypto ikev1 policy ikev1-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ikev2 policy ikev2-default
--More-- isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
crypto ikev1 remote-vpn
crypto ikev2 remote-vpn
crypto auto-ipsec-secure
crypto load-management
crypto remote-vpn-client
interface radio1
wlan "Staff WiFi" bss 1 primary
wlan "Student WiFi" bss 2 primary
antenna-mode 2x2
interface radio2
wlan "Staff WiFi" bss 1 primary
wlan "Student WiFi" bss 2 primary
antenna-mode 2x2
interface bluetooth1
shutdown
interface ge1
switchport mode trunk
switchport trunk allowed vlan 10,30,40
switchport trunk native vlan 10
switchport trunk native tagged
interface vlan10
--More-- description Management
ip address 172.16.10.92/24
interface vlan30
description Staff
interface vlan40
description Student
interface pppoe1
use firewall-policy default
use client-identity-group default
virtual-controller auto
virtual-controller management-interface ip address 172.16.10.252/24
virtual-controller management-interface vlan 10
rf-domain-manager capable
logging on
controller vlan 10
service pm sys-restart
router ospf
adoption-mode controller
!
rf-domain default
location LVL1
timezone Asia/Kuala_Lumpur
country-code my
--More-- use nsight-policy default
!
ap7632 94-9B-2C-14-FE-37
use profile default-ap7632
use rf-domain default
hostname SJIS-1F-AP-2
!
ap7632 94-9B-2C-15-0E-40
use profile default-ap7632
use rf-domain default
hostname ap7632-150E40
no adoption-mode
!
ap7632 94-9B-2C-15-10-9D
use profile default-ap7632
use rf-domain default
hostname SJIS-16F-AP-2
!
ap7632 94-9B-2C-15-10-FC
use profile default-ap7632
use rf-domain default
hostname ap7632-1510FC
!
--More-- ap7632 94-9B-2C-15-11-47
use profile default-ap7632
use rf-domain default
hostname SJIS-16F-AP-1
Good Day. I have 18 units of Wing7630 and configure as Dynamic VC.
my question is all the AP I had configure IP address at Interface VLAN. when the AP is up why all the AP will go to the same IP address.
show run
!
! Configuration of AP7632 version 5.9.2.5-001R
!
!
version 2.6
!
!
client-identity-group default
load default-fingerprints
!
ip access-list BROADCAST-MULTICAST-CONTROL
permit tcp any any rule-precedence 10 rule-description "permit all TCP traffic"
permit udp any eq 67 any eq dhcpc rule-precedence 11 rule-description "permit DHCP replies"
deny udp any range 137 138 any range 137 138 rule-precedence 20 rule-description "deny windows netbios"
deny ip any 224.0.0.0/4 rule-precedence 21 rule-description "deny IP multicast"
deny ip any host 255.255.255.255 rule-precedence 22 rule-description "deny IP local broadcast"
permit ip any any rule-precedence 100 rule-description "permit all IP traffic"
!
mac access-list PERMIT-ARP-AND-IPv4
permit any any type ip rule-precedence 10 rule-description "permit all IPv4 tra--More-- ffic"
permit any any type arp rule-precedence 20 rule-description "permit all ARP traffic"
!
ip snmp-access-list default
permit any
!
firewall-policy default
no ip dos tcp-sequence-past-window
no stateful-packet-inspection-l2
ip tcp adjust-mss 1400
!
!
mint-policy global-default
!
meshpoint-qos-policy default
!
wlan-qos-policy default
qos trust dscp
qos trust wmm
!
radio-qos-policy default
!
--More-- wlan "Staff WiFi"
description Staff WiFi
ssid Staff_SJIS
vlan 30
bridging-mode local
encryption-type ccmp
authentication-type none
wpa-wpa2 psk 0 St@ff12345
!
wlan "Student WiFi"
description Student WiFi
ssid Student_SJIS
vlan 40
bridging-mode local
encryption-type ccmp
authentication-type none
wpa-wpa2 psk 0 1234567890
!
!
management-policy default
telnet
no http server
https server
--More-- rest-server
no ftp
ssh
user admin password 1 a2f002244f271fe5f29c8b864f62d644073f7c91938c21b0b2964e47293e4892 role superuser access all
snmp-server community 0 private rw
snmp-server community 0 public ro
snmp-server user snmptrap v3 encrypted des auth md5 0 admin123
snmp-server user snmpmanager v3 encrypted des auth md5 0 admin123
!
event-system-policy default
!
nsight-policy default
!
profile ap7632 default-ap7632
ip name-server 8.8.8.8
ip name-server 8.8.4.4
ip default-gateway 172.16.10.254
autoinstall configuration
autoinstall firmware
crypto ikev1 policy ikev1-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ikev2 policy ikev2-default
--More-- isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
crypto ikev1 remote-vpn
crypto ikev2 remote-vpn
crypto auto-ipsec-secure
crypto load-management
crypto remote-vpn-client
interface radio1
wlan "Staff WiFi" bss 1 primary
wlan "Student WiFi" bss 2 primary
antenna-mode 2x2
interface radio2
wlan "Staff WiFi" bss 1 primary
wlan "Student WiFi" bss 2 primary
antenna-mode 2x2
interface bluetooth1
shutdown
interface ge1
switchport mode trunk
switchport trunk allowed vlan 10,30,40
switchport trunk native vlan 10
switchport trunk native tagged
interface vlan10
--More-- description Management
ip address 172.16.10.92/24
interface vlan30
description Staff
interface vlan40
description Student
interface pppoe1
use firewall-policy default
use client-identity-group default
virtual-controller auto
virtual-controller management-interface ip address 172.16.10.252/24
virtual-controller management-interface vlan 10
rf-domain-manager capable
logging on
controller vlan 10
service pm sys-restart
router ospf
adoption-mode controller
!
rf-domain default
location LVL1
timezone Asia/Kuala_Lumpur
country-code my
--More-- use nsight-policy default
!
ap7632 94-9B-2C-14-FE-37
use profile default-ap7632
use rf-domain default
hostname SJIS-1F-AP-2
!
ap7632 94-9B-2C-15-0E-40
use profile default-ap7632
use rf-domain default
hostname ap7632-150E40
no adoption-mode
!
ap7632 94-9B-2C-15-10-9D
use profile default-ap7632
use rf-domain default
hostname SJIS-16F-AP-2
!
ap7632 94-9B-2C-15-10-FC
use profile default-ap7632
use rf-domain default
hostname ap7632-1510FC
!
--More-- ap7632 94-9B-2C-15-11-47
use profile default-ap7632
use rf-domain default
hostname SJIS-16F-AP-1
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-26-2019 02:16 PM
Hi,
I would assume you're talking about the 172.16.10.92/24 IP address?
From what I can see, all APs are using the same IP because said IP address is configured in the AP profile.
profile ap7632 default-ap7632
--
interface vlan10
ip address 172.16.10.92/24
--
Since this is a global setting, all adopted APs will use this profile and consequently the same IP address.
#self
#int vlan 10
#ip address 172.16.10.92/24
#com wr
#sh context
If you wish all other adopted APs to have a unique static IP address, then you will have to configure same through the Virtual controller.
This might help:
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-assign-a-static-IP-to-a-WiNG-AP-or-controller-from-CLI
Thank you
Chris
I would assume you're talking about the 172.16.10.92/24 IP address?
From what I can see, all APs are using the same IP because said IP address is configured in the AP profile.
profile ap7632 default-ap7632
--
interface vlan10
ip address 172.16.10.92/24
--
Since this is a global setting, all adopted APs will use this profile and consequently the same IP address.
- Log into the VC and remove the IP address from the profile. You can set it to DHCP if you so wish.
- Configure this IP address as an override so that it is unique to the VC.
#self
#int vlan 10
#ip address 172.16.10.92/24
#com wr
#sh context
If you wish all other adopted APs to have a unique static IP address, then you will have to configure same through the Virtual controller.
This might help:
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-assign-a-static-IP-to-a-WiNG-AP-or-controller-from-CLI
Thank you
Chris
Christoph S.
