Mint neighbours are not showing correctly

[Warlock26]

one of my site having around 22 AP  and all this device are online and able to view in rf-domain but when i checked the mint neighbours it not showing  neighboring AP list  as a part of troubleshooting  i have pinged from from ap to ap its working fine also i checked the adoption status it shows ap is adopted to controller correctly .and when i checked wireless  clients ,device are    showing in  ap but not in  controller  and we are only using single vlan but still mint neighbour establishment is not happening.

[ckelly]

There you go.

Noticed that MINT level-1 was not seeing any of your neighbor APs...which relies on the defined control VLAN.  That was going to be my next question. 🙂

Good catch.

[Warlock26 · Accepted solution]

issue has been resolved actually i didn't  enabled vlan for control traffic in rf-domain once i enable that  its start to work and i am able to view mint neighbours in ap now and also i am able to view wireless clients from controller side

[Warlock26]

below are the output i am getting 

#show mint info
Mint ID: 55.B4.B4.40
0 Level-1 neighbors
Level-1 LSP DB size 1 LSPs (1 KB)
1 Level-2 neighbors
Level-2 LSP DB size 2 LSPs (1 KB)
Level-2 gateway is self
Level-2 leaf node
Reachable adopters: 12.BC.6D.0A
Max level-1 path cost: 0 (to 55.B4.B4.40)

#show mint mlcp
MLCP VLAN state: MLCP_DISCOVERING
MLCP VLAN Hello Interval: 4s(default), Adjacency hold time: 13s(default)
  Potential VLAN links:
  All VLANs were scanned 1022 times
MLCP IP: ENABLED
MLCP IPv6: ENABLED
MLCP IP/IPv6 state: MLCP_DONE
MLCP IP Hello Interval: 15s(default), Adjacency hold time: 46s(default)
  Potential L3 Links:
    172.17.100.144, 172.19.97.144
  Link created to 172.19.97.144:24576 level 2

#show mint stats
0 Level-1 neighbors
Level-1 LSP DB size 1 LSPs (1 KB)
Last Level-1 SPFs took 0.000s
Level-1 SPF (re)calculated 5 times.
1 Level-1 paths.
1 Level-2 neighbors
Level-2 LSP DB size 2 LSPs (1 KB)
Last Level-2 SPFs took 0.000s
Level-2 SPF (re)calculated 24 times.

and when i tried # show global domain manager in Access point i got AP   in hostname column

[ckelly]

Can you run these and post the outputs?

show mint info

show mint mlcp

show mint stats

I’m assuming these APs are being managed by a WiNG controller…

Is the WiNG controller the RF-Domain Manager or this RF-Domain...or one of the APs?

• check by running show global domain managers and look for the RFDomain and then check the Host Name column to see if it’s an AP or a controller