cancel
Showing results for 
Search instead for 
Did you mean: 

Support converting AP 0622 to autonomous mode

Support converting AP 0622 to autonomous mode

DoTrungDong
New Contributor

I have AP 0622. It is running with RFS7000 controller.

Can you tell me, does this device have a standalone os version, or does it have to be run with a controller?

Thanks,

1 ACCEPTED SOLUTION

Christoph_S
Extreme Employee

Hello Do,

 

This is a dependant AP that has to be adopted by a controller to function. It cannot be converted into a standalone unit. 

 

Thank you,

Christoph S.

View solution in original post

4 REPLIES 4

DoTrungDong
New Contributor

You’d have to search for the datasheet as that’s a very old model.  Only certain AP models can act as virtual controllers, and that’s usually reserved for the higher end models.

Note that this link is not provided by Extreme, but here’s a link to the spec sheet:  The wording you’d be looking for is “virtual controller,” and this is absent from the spec sheet.

AP 622; COST-EFFICIENT SINGLE RADIO 802.11a/b/g/n WIRELESS ACCESS POINT (barcodesinc.com)

All that said, that AP is only capable of 802.11n.  Have you considered upgrading to something more current?

 

That means AP 0622 cannot run independently, but it must run through the controller. Thanks !

Curtis_Brabham
New Contributor III

You’d have to search for the datasheet as that’s a very old model.  Only certain AP models can act as virtual controllers, and that’s usually reserved for the higher end models.

Note that this link is not provided by Extreme, but here’s a link to the spec sheet:  The wording you’d be looking for is “virtual controller,” and this is absent from the spec sheet.

AP 622; COST-EFFICIENT SINGLE RADIO 802.11a/b/g/n WIRELESS ACCESS POINT (barcodesinc.com)

All that said, that AP is only capable of 802.11n.  Have you considered upgrading to something more current?

 

DoTrungDong
New Contributor

Do you have any references, thank you!

Christoph_S
Extreme Employee

Hello Do,

 

This is a dependant AP that has to be adopted by a controller to function. It cannot be converted into a standalone unit. 

 

Thank you,

Christoph S.
GTM-P2G8KFN