Wing 5.8.5 Country code AP7532 -xxx WR

[Phil_storey]

I have an AP732-67040-WR, The controller see's it fine but the AP LED's are just on, So I know this is invaild country code, Via the CLI I see the following

"error setting country of operation. gb [United Kingdom] not supported on hardware model AP-7532-67040-WR"

It will work under generic 1 -g1 or the others upto g7
What is g1 etc in comparrison to when an AP is set to GB [ United Kingdom ]

[Christoph_S]

Just upgraded the lab WR AP7532 to 5.9.0.0 and was able to see EU country codes in there:

[Vedran_Jurak]

I would suggest upgrading to 5.9.0 because the release notes state: "WiNG 5.9.0 enables support to configure EU country codes on WR SKU. Downgrading the same device to pre WiNG 5.9.0 release software doesn’t support EU country codes."

[Bin]

Hi Phil,

AP-7532-67040-WR AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point external antenna International version
AP-7532-67040-EU AP-7532 dual radio 802.11ac 3x3:3 MIMO Access Point external antenna EU version

Select only the country in which you are using the device. Any other selection will make the operation of this device illegal. Some Access Points are specifically designed to operate in certain countries (Example; -US for the United States, -EU for the European Union).

Best regards,
Bin

[RobertZ]

You can see difference for each country/region here: https://en.wikipedia.org/wiki/List_of_WLAN_channels

[Phil_storey]

OK, what is the difference RF wise between the EU and WR versions ?