FAQs - Page 6 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

I/G/C5/C3/B5/B3-Series f/w 6.42.xx Loses SNMP Contact after System Reboot

Article ID: 13707 Products I-Series, firmware 6.42.01.0046 through 6.61.05.0009 G-Series, firmware 6.42.01.0046 through 6.61.05.0009 C5-Series, firmware 6.42.01.0046 through 6.61.05.0009 C3-Series, firmware 6.42.01.0046 through 6.61.05.0009 B5-Serie...

cli asterisk after reboot of 400-48t. Changes were saved but asterisk appears after reboot

Newly created stack 7.8.4 firmware with saved configuration reboots and has a * in front of CLI like it needs a save. I run save conf primary and it goes away. Run reboot command and switches (2 in stack) reboot and it comes back. my changes are s...

S/N/K-Series Policy to permit SNMP Requests only from Specific IP Addresses

Article ID: 14649 Products S-Series Matrix N-Series DFE K-Series Goals Sample configuration. Configure Policy so that only certain IP addresses can SNMP-access the device. Solution This may be accomplished as follows: code:set policy profile 1 n...

N/S-Series MAC Authentication Failures will not Retry with Default Quietperiod

Article ID: 12933 Products Matrix N-Series DFE S-Series Changes Enabled MAC Authentication ('code:set macauthentication...', 'code:set radius...', 'code:set multiauth...'). Users on one or more ports have failed authentication, for any reason. Sy...

By Default only 802.1x Authentication is offered on the DFE

Article ID: 7664 Products Matrix N-Series DFE Firmware 4.00.50 and higher Protocols/Features MUA 802.1x PWA MAC Authentication CEP Symptoms Only 802.1x is offered as an authentication method. Cause The only authentication type supported in the d...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN