FAQs - Page 97 - Extreme Networks

FAQs

Frequent Asked Questions

Forum Posts

Sorted by:

Start a conversation

G-Series SNTP Does Not Function Without a Configured Host IP Address

Article ID: 11562 Products G-Series, firmware 6.03.00.0022 and lower Changes Configured Simple Network Time Protocol ('set sntp...'). Did not configure a host IP address ('set ip address...'). Symptoms SNTP is not functioning. Cause With earl...

Guidelines for use of the SecureStack & G-Series Host IP Address

Article ID: 5573 Products SecureStack C3, C2, B3 G-Series Symptoms 'set ip address mask gateway' "IP Address/Netmask entered conflicts with the configured IP Address/Netmask of a a router interface." 'ip address' 'set host vlan' "Subnet conflict ...

Login sequence using Radius Authentication

Article ID: 6750 Products SmartSwitch 2000 2nd Generation SmartSwitch 6000 2nd Generation SmartSwitch 6000 3rd Generation Matrix E1 Protocols/Features Radius Solution Shown below are possible event sequences that would apply to a Serial or Teln...

802.1x Supplicant is Constantly Reauthenticating in DFE LAG Environment

Article ID: 11537 Products Matrix N-Series DFE Changes Configured for 802.1x authentication ('set dot1x...'). Acting as a core device, connected into the network via 802.3ad Dynamic or Static LAGs. Symptoms Dot1x supplicants are constantly re-a...

Background about RFC 3580's VLAN Assignment upon 802.1x Authentication

Article ID: 7312 Protocols/Features Radius Tunnel Standards RFC 3580 RFC3580 802.1x Symptoms "Tunnel-Type" "Tunnel-Medium-Type" "Tunnel-Private-Group-ID" Cause This article reproduces only the Abstract and Tunnel Attributes sections of RFC358...

Top Kudoed Authors

User

Count

26

1

1

1

1

GTM-P2G8KFN