Copper port not getting up between 2 extreme 220 series switches. The copper cable length is around 90 meters. But when we connect both these switches back to back (means at same location) then the p...
I have a port-channel between a Cisco 4500 and a summit x450 with two interfaces. When monitoring them, I only see the traffic through one interface, it is not distributed by the second member.
Dear All, I am new to the extreme network infra and previously I worked for Cisco and Juniper. Is there any syntax document related to each (like configuring l3 vlan, l2 vlan, ospf, trunk etc)
Hi, We have eight VSP-8404 that were recently upgraded from 6.1.3.0 to 8.0.7.0 and after the upgrade one of them has started sending a temp high trap. rcn2kCardZoneOverheat [1] rc2kCardIndex.0 (I...
We have detected that some users are experiencing slow traffic, specially while they are uploading files to a shared server (located in the same vlan as the computer or in different vlan). They uploa...
code: Hi people !! I am form Chilean :) a query, I need that to vlan that are configured to the SW, receive DHCP to is Server DHCP external... for exmaple Pfsense, Winds server or other server lin...
Hello guys,
I have a problem with C2G124-24 switch. It looks like it cant boot because all leds are on while CPU led is blinking green. I tried to connect to the switch via putty but nothing appear...
Good morning, I have a question related to Fan Speed Control behavior on an S8-CHASSIS-POE Running “show system hardware” I got Fan1 Temp, Fan2 Temp, Ambient Temp and temperature for each inst...
Hi, I have Enterasys N7 switch. I have the following configuration on switch. Problem: Devices in different vlan can not ping each other. Intervlan routing problem. configure termina...
Hello everyone,
I need to replace faulty SK8008-1224-F8 module on bonded S4 chassis. The module has 4 dedicated VSB ports.
Here are my questions:
Is there any procedure for such repla...