X440-g2 user read-only account “show configuration” command not working. IOS version running : 21.1.5.2 patch1-2Please let me know is there any guide which lists all the commands which we can run under read-only account?
Copper port not getting up between 2 extreme 220 series switches. The copper cable length is around 90 meters. But when we connect both these switches back to back (means at same location) then the port gets up. We tested copper cable via LAN tester ...
We have 2 ×460-g2 connected in stack. One of the switch went faulty now. We received new switch against RMA and we are going to add it back to the stack.Now the issue is by mistake we disabled stacking on working x460-g2 switch. So is the config for...
We have a requirement in our office for guest setup. Whenever a guest comes & need internet access, he should connect to guest SSID. The captive portal should ask for guest name, name of the person he is visiting & email of the employee whom he going...
connection with X2-10GB-LR & Extreme 10302 is not coming up. we tried with tx/rx swap also we used multiple SM/MM cables. So I want to know is there any other dependency other than frequency like protocol & standards or signaling rate?
I upgraded the switch to latest IOS i.e. EXOS 30.7.1.1-patch1-86 but still I am unable to execute “show configuration” command with read-only user account. It is giving following error. Please help to resolve.ex.x450.chi.a.1 > shiw configurationThis ...
