There is a nice debug command in the CLI called "service radius test".This will allow to check the Radius Server connection:service radius test <IP address radius server> port <radius port> <shared secret> <username> <password>e.g.:service radius tes...
Yes, the DNS ALG needs to be active (CLI command "alg dns").But this is by default.For interception of the DNS request and the proper answer, you need to configure the server mode as centralized-controller and a DNS alias for the server host, e.g. "c...
Yes, this is possible.1. The webserver for the captive portal webpages is your controller. Therefore, the controller must have an IP address in VLAN 980.2. The authentication server is your controller (again). You have to configure all the radius ser...
Your captive portal should run in server mode "centralized controller".Then you have to map the captive portal to your controller and not to one specific access point.Furhermore your controller needs to have an IP address in the captive portal VLAN (...
