Extreme Networks

bear · 10-04-2018

I have dozens of Aerohive switches and APs, and I've run into a problem recently where one of my switches doesn't 'take' the update when I change the device's name in HM. Consider this scenario: Unpack SR2348P, add serial number to HM, boot device, ...

bear · 05-08-2018

I have configured my HiveManager NG network policy with an SNMP profile that specifies two different IPs. Presumably, my switches are firing away SNMP traps at these IPs (I haven't looked) but my switches are not accepting SNMP polling at the same c...

bear · 05-03-2018

We are installing some new gear into our HiveManager NG in preparation to migrate our APs and 20xx series switches from our aged HiveManager Classic to our new HM NG. I noticed early on that the Connected Clients display in NG always just shows a l...

bear · 10-23-2018

I just went to HiveManager Classic interface and exported all 5 remaining devices to CSV. The serial numbers of the device are in the first column; here are the column headers: //Serial Number,Node ID,Host Name,Device Model,Device Function,Netw...

bear · 10-23-2018

If you actually followed the guide and exported your inventory (page 8, "click Device Inventory > Export to export a list of the selected devices as a .csv file") like it says, then you do have a list of your devices and their serial numbers. If you ...

bear · 10-17-2018

By the way, I have a support case open for this- turns out that once migrated from Classic to NG, all of my HiveOS-based devices (access points, SR2000 switches) ignore their SNMP configuration, while the newer Nimitz-based switches (the SR2200/23...

bear · 10-10-2018

Just pretend like the ATOM is a normal AP wired and configure it, then try to connect to the network via wired AP using the ATOM. Now enable backhaul mesh on one wi-fi interface on the ATOM plus backhaul mesh on the same radio type of a nearby wired...

bear · 10-05-2018

After connecting to the device via SSH, I noticed that the device had the correct name, it just didn't display the correct name in the HM device list. I don't know if this is a known workaround, but stopping and starting the HM agent worked for me, w...

Extreme Networks

User Statistics

User Activity

Why won't my switch 'take' a device name update via HiveManager? 2 dozen switches and 2 of them seem to 'ignore' being renamed.

How to enable SNMP polling of my 2208/2324/2348 switches via HiveManager NG?

When is the Connected Clients display for switches in HiveManager NG going to work?

Re: How do I move from Classic to NG ?

Re: How do I move from Classic to NG ?

Re: How to enable SNMP polling of my 2208/2324/2348 switches via HiveManager NG?

Re: AP30 ATOM Install - start to finish?

Re: Why won't my switch 'take' a device name update via HiveManager? 2 dozen switches and 2 of them seem to 'ignore' being renamed.