I deploy 4 APs at home, here is the cli output of the original ACSP
# show acsp
Interface Channel select state Primary channel Channel width Power ctrl state Tx power(dbm) Use Last Selection
--------- --------------------- ---------------- ---...
hi, community.Q1:Because the APs are deploy on a restricted Internet access environment. so, any possible to implement local ppsk with cwp for end user register them-self?Q2:Is there IDM virtual appliance out there to deploy locally?
I could clear the current , backup, failed config with `_clear config` command, but could not find any cli to clear the running config except `reset`.anyone know how to do it?
After an update of delta config, the ssid config are disappeared. I check it out through CLI. so the ssid is not broadcasting anymore.I have tried:1. update complete config2. rebuild the ssid: copy the old one(jike-5G) to a new renamed ssid(jike-5G-b...
of course
ah230-703a40_hkxd_living#show int
State=Operational state; Chan=Channel;
Radio=Radio profile; U=up; D=down;
Name MAC addr Mode State Chan(Width) VLAN Radio Hive SSID
----------- -------------- ---------...
I found that xiq could set AP to restore back to ethernet backhaul by setting radio profile.I did it, but it seem didn't work. after unplug rj45, wait for 1 min, plug back rj45.
ah230-703a40_hkxd_living#show hive vhm_hkxd nei
Chan=channel number; Pow...
here are cli output of the restored ap:
ah230-703a40_hkxd_living#show hive vhm_hkxd nei
Chan=channel number; Pow=Power in dBm;
A-Mode=Authentication mode; Cipher=Encryption mode;
Conn-Time=Connected time; Hstate=Hive State;
Mac Addr Ifname C...
@Areck DegeneffeUnfortunately, even after the wired backhual restored. The AP still choose wifi as backhual, this is ridiculous, any possible to change this situation?
