Dear All
I try to using FlexView to aggregate client's information (IP, MAC, and which port he come from) on swirch
In switch like 430 , 440 it seem no problem, and OIDs I us like:
but the same FlexView I using to show BD8806 's client inform...
When I using Netsight 6.2.0.221 to make some summit switches upgrade their firmware.
I need stay in front of my Inventroy Management 's firmware upgrade wizard to make sure everyone was running new firmware.
If i using schedule to upgrade and res...
When I using Netsight 6.2.0.221 to make some summit switches upgrade their firmware.
I need stay in front of my Inventroy Management 's firmware upgrade wizard to make sure everyone was running new firmware.
If i using schedule to upgrade and res...
I think you need check some setting in your network :
1. Routing and gateway in your network.
you setting gateway on your switch , you also need check session reply can back to you .
2. DNS setting is correct before you ping FQDN
you need setti...
Dear suresh
switch 's version 15.3
BD 's version 12.4
Did you mean it different OIDs between two version so I get wrong show ?
Hunt.Liao
2015/10/05 12:07 PM
Taiwan
