Extreme Networks

I have a new setup of purview and sensor. All configuration for sensor and Purview tunnel is well done. The purview report to netsight as it is shown in status-diagnostics. as well as the browser show some for applications, But the reports dashboard...

Hello Team, I can not connect to Netsight server after I have restored database. At the end of the restoring I got message that database is restore with error but not fatal and the server should be restart. I just pressed ok and the server did res...

fHi, Any idea where can I find Visio Stencils for BDXA-10G48T. I have downloaded BlackDiamond X8 from http://www.extremenetworks.com/support/visio-stencils but I could not find any Stencil for BDXA-10G48T Thanks in advance,

I have a setup of wireless controller C5210 v09.21.06.0006 integrated with NAC IA-A-300 for dot1.x authentication only without assessment. I installed this NAC 3 weeks ago. Till yesterday the NAC showed the AP name that the End-system connected to a...

I have a setup of more than 100 X440-48p switchs firmware 15.6.4.2. There are two switches which (if the power cut off and return back) do not boot till unplug and plug the power cable. Is there any advice! Thanks in advance.