I need to setup a port channel with a Cisco switch. I just want to verify the steps I need to perform.
This is what I have on the Cisco side for the port channel config so far:
interface Port-channel1
description Etherchannel to summit
...
Here was the final solution that worked for me:
https://gtacknowledge.extremenetworks.com/articles/Solution/LACP-incompatibity-between-extreme-and-cisco
When I run the VM in workstation 11, I get a watchdog timeout that slowly increments and does not allow me to log in. Any ideas what this may be? Do I need to adjust my VM settings?
