Extreme Networks

social · 09-20-2018

I have a problem sending a configuration to an AP1130. The AP does actually not accept the config. Here below the details and the steps I followed for troubleshooting.Would anybody have an idea? The AP should actually be used for a point-to-point me...

social · 08-24-2018

I have deployed a P2P bridge using two AP1130 and directional antennas. It was running on 5G channel 112 (set manually to 112 with full transmission power). It has been running without any issues for several months. Now the bridge is not working anym...

social · 09-20-2018

Thanks a lot Sam. File sent by mail.

social · 09-20-2018

I did not get an Update failure message as I did a "Complete Configuration Update" with "Update Activate at next reboot (requires rebooting manually)" and rebooted later. I now tried "Delta Configuration Update". The error message it gives my is: "No...

social · 08-30-2018

I cant deploy the config to the AP. No no idea why. Still the same as described above.Anyone has an idea?

social · 08-27-2018

After reset to factory defaults, the AP does not accept my config (not sure if that was the case before as well but I would guess so) What I did:Reset device to DefaultComplete Configuration Updatewith the option: Activate at next reboot (requires re...

Extreme Networks

User Statistics

User Activity

AP1130 does actually not accept the configuration I try to send from Hive Manager.

Problems with WIFI point to point bridge using AP1130

Re: AP1130 does actually not accept the configuration I try to send from Hive Manager.

Re: AP1130 does actually not accept the configuration I try to send from Hive Manager.

Re: Problems with WIFI point to point bridge using AP1130

Re: Problems with WIFI point to point bridge using AP1130