Extreme Networks

aurfalien

Hello,I was curious what the best way to configure trunking between a Foundry Turbo Iron (I sure miss those old names) switch and a Brocade MLXe switch.In the past, trunking between Foundry switches meant using the trunk commands to do so. And it's ...

aurfalien

Hello,I was curious if any one knew wether my MLXe-8 supports link aggregation? I looked at the manual and logged into the switch itself and can't find any mention of it. Upon executing "link-" and tabbing for command completion, I don't see any me...

aurfalien

Hello,I've an MLXe rockin it and was curious if it has some sort of battery that keeps date and time? During any sort of power failure the date resets to Dec 31 of some year and NTP no longer works because of the date being so far off. Not a huge d...

aurfalien · 04-17-2025

Hello,I'm unsure if this is the correct forum to post on seeing that I'm talking about very old gear, so feel free to direct/correct me, etc...I've about 6 Foundry SuperX chassis with various 1Gb and 10Gb modules and several of the Brocade 24 port 10...

aurfalien

Thanks James. I do have all those manuals as well as firmware so all good. I'll trial and error but being offsite/remote will make it a challenge. Will have hands on site for this.

aurfalien

Truly golden, many thanks!!!

aurfalien

Welp, a little follow up, I found this solution very odd. I performed the following commands from enable mode;lag "ANX" static id 1ports ethernet 5/1 to 5/4 primary-port 5/1deployAnd it seems to be working. Although I'm totally unsure if this is cor...

aurfalien · 06-05-2025

Is it possible when in after setting "no route-only" to assign the over all switch an IP address? I currently have the management port set with an IP address which is how I'm managing it.

aurfalien · 04-17-2025

Since you're here, I was curious as this is a general design question. Would there be any advantages to implementing Layer 3 in a LAN, such as priority queueing etc... And are IP based VLANs as secure as port based VLANs? My MLXe-8 can do a lot of...

Extreme Networks

User Statistics

User Activity

Foundry TurboIron switch to MLXe-8 switch via trunking

MLXe and link aggregation 802.3ad

MLXe time and date persistence

Migrating from Foundry SuperX base layer 2 to Brocade MLXe-8

Re: Foundry TurboIron switch to MLXe-8 switch via trunking

Re: MLXe and link aggregation 802.3ad

Re: MLXe and link aggregation 802.3ad

Re: Migrating from Foundry SuperX base layer 2 to Brocade MLXe-8

Re: Migrating from Foundry SuperX base layer 2 to Brocade MLXe-8