Hi SupportI was looking at the 5720 HW guide, but I don't quite understand the specs regarding its DRAM."2 GB DDR4 ECC memory, expandable to 4GB"I looked through IRIS, and there are no expansion options. So, how do I configure the 4GB memory option?
When I was use the datasheet for Extreme Optics, I found that some of the content appears to be incorrect , The part numbers for the 40F‑DACA and the 40G‑DACA breakout are the same . please refer the content as picture
Hi SirsWe want to connect a 1G base-T gbics to the 5120-24x for testing.Then we found that only the first 12 ports were recognized and port up, the back 12 ports were recognized but no port up,I checked the optics inside10065 is "min. S/W rev. 33.3. ...
Hi SirsThe user guide for the 4000 series mentions that there are Basic and Full CLI commands.What I want to confirm is which manual lists all the Basic instructions completely.Are the commands in the Common Commands section of the 4000 series user g...
Hi SirsWe have encountered VSP 8404C after 497 days, the system automatically rebootedWe also searched related KB and found that the following models describe why this problem occursEthernet Routing Switch 4500 running any supported software versionE...
Thank you for your reply. If possible, we would still appreciate a detailed and clear set of hardware specifications to avoid any ambiguities or misunderstandings when defining the hardware requirements during equipment planning.
Hi Sirsalmost NX series will be EOS , but Wing has a new controller CX9000I want to know CX9000 support tunnel mode ?I personally believe that the CX9000 probably doesn't support tunnel mode because the CX9000 is still using a container to encapsulat...
