Data Center (VDX)
Questions and discussions about VDX
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

portchannel load-balance available modes

I need to bond two links from an AP, the AP only support SRC MAC+DST MAC, DST MAC, and SRC MAC. I didn't see one that match in the manual....What load balance should I pick?  I wasn't sure on the description because they all say "and".  In that conte...

mbze430 by New Contributor II
  • 7 Views
  • 0 replies
  • 0 kudos

Resolved! Boot PROM password recovery

Hello, good morning everyone!I recently bought a BC 6510 switches that have the PROM password set. Could someone help me to recover?My recovery string is : 0nasdIKewSsGgAZbascQnQ==I greatly appreciate any help.

danipapi by New Contributor
  • 108 Views
  • 1 replies
  • 0 kudos

Resolved! need help VDX 6740 in-band management configure

Having a bit of trouble configuring the VDX 6740 so I can access the management cli via ssh from anywhere (in-band).My management VLAN is 100 and I figure I try to forward from the port-channel port since it's the trunk portHere are the parts of the ...

mbze430 by New Contributor II
  • 503 Views
  • 7 replies
  • 0 kudos

Resolved! port routing difference between context rb 1 and interface?

Once again I am confused with the context between rbridge and interface to assign an ip address.If I wanted to connect a port, TE 1/0/24 to an internet firewall/router.  Which one is the correct context to ? #conf#int te 1/0/24#no switchport#ip addre...

mbze430 by New Contributor II
  • 227 Views
  • 2 replies
  • 1 kudos
GTM-P2G8KFN