Hi, Enable Analytics on my configuration, and I it's already reporting data in the Poximity&Presence section of the Aerohive portal. I am trying to make the call of this data through webhooks: The problem is that I'm not getting any information about...
I have switched the Disable UNII-3 Channels option on in a radio profile as some of my clients do not support these channels. This causes delta config updates to fail for older devices (AP121 and AP330) with the error message "The CLI 'interface wif...
I created a new test account, once inside a policy and a location and purchased a new AP121 which I added in HiveManager. I don't see the SSID I created hence I can't use the AP. Why could that be?
When i setting the power to 20dbm, it's display as below: AP02#interface wifi1 radio power 20Warning: Power 20 exceeds HW limit(regulatory 10, board 19), forced to 10 AP and HM 's version both are 8.1r2
I just installed 3 AP150W's and have only managed to get 150 Mbit out of them, as the CPU just pegs. I'm using HiveManager Connect, and even SSHd in and turned off QOS. There's definitely more RF performance to be had, as one would expect from a devi...
