cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

I have a AP330 that stopped client access, I replaced with same AP330, same thing happened. Discovered power off/on fixes it. What may be causing this? It's located in a small room with cinder block wall, room is warm not hot.

I have a AP330 that stopped client access, I replaced with same AP330, same thing happened. Discovered power off/on fixes it. What may be causing this? It's located in a small room with cinder block wall, room is warm not hot.

kenneth_scholl
New Contributor
I have a AP330 that stopped client access, I replaced with same AP330, same thing happened. Discovered power off/on fixes it. What may be causing this? It's located in a small room with cinder block wall, room is warm not hot.
7 REPLIES 7

bruce_stahlin
Contributor III

What does HiveManager reveal about the clients? Does the WAP report clients in HM? Do you have console or ssh access to the WAP? What does the "show station" command report? If you're using HM Classic, have you run client monitor?

kenneth_scholl
New Contributor

The light remains white. If I reboot it, it will go through the various lights until completing the boot finishing with white but it still will not let any clients to access it. I unplugged it again to see how long it take before it "locks up".

bruce_stahlin
Contributor III

Are you losing capwap, i.e. what color is the LED on the WAP when connectivity is lost?

GTM-P2G8KFN