learned mac address refer to group
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-25-2018 07:04 AM
I have created a DEVICE GROUP with ITS INTERNAL only two port/pc so I STARTED the flexview "learned mac addresses" to know if the 2 pc are turned on but my view show nothing.
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-25-2018 10:54 AM
YES ! but I need to show only the computers in that group
otherwise what is the purpose of creating groups?
otherwise what is the purpose of creating groups?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-25-2018 10:54 AM
I'm afraid so 😞
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-25-2018 10:54 AM
I get the same result..... I'd open a GTAC ticket as I'm not sure whether that will work with this flexview.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-25-2018 10:54 AM
Sorry  I am calm with you ..... I am less calm with Netsight !!
