XIQ-SE ZTP is not loading AAA/radius configuration to X440-G2

[Adam13]

Hi,

I'm building up my XIQ-SE deployment prior to receiving an order, I've been having a few issues and I hope someone experienced may be able to spot the cause on this one.

I previously had these AAA settings being loaded to the switch when I pushed the ZTP configuration but now the "show configuration detail" shows radius as disabled and none of the settings have been loaded (everything else has been pushed correctly).

I was troubleshooting AP aware and changed some settings while considering having NAC do the LDAP requests (instead of being a proxy to NPS), I'm expecting I changed a setting while looking at these options but I can't find what's different. As a side note I have had this happen previously and it returned to normal after i rebooted the Extreme servers but no luck this time.

Any guesses to what I need to check or good references to look over? I have been using the online guide but it's hard to find examples of how the settings are utilized together.

Pointers are appreciated.

[Adam13]

Hi Sam,

Thank you for taking time to look at this, I had other issues with the earlier release but have upgraded last week to the latest version 10.11.11.37

[SamPirok]

Hi Adam, I've been looking in to this for you and I found a few closed cases that had similar symptoms and resolved them with an upgrade of XIQ-SE. Could you tell me what version of XIQ-SE you're using? The cases I found were using pre-21.11.10.57 versions.