Hello @agroszer,
This is normal behaviour with all our APs. When an AP loses connection to XIQ, it will revert to the best known working config (after 10 mins) to try and find its way back to XIQ. Check your configs to make sure that the changes made in the network policy are good and look for the reason the AP is losing connection after pulling the configs.
When the AP pulls the config and loses connection, try SSHing into it and run the following commands:
Show int mgt0 (check vlans, IP address, DGW and basic stuff)
Show capwap client (check to see which parameter is missing)
Show DNS (check DNS settings)
Ping the default gateway
Ping 8.8.8.8
Ping www.extremenetworks.com
See where ping fails.
If all else fails, reset the AP. You can also select it under Manage > Devices > ACTIONS > Revert Device to Network Policy Defaults
I hope this helps,
BR,
Christoph S.
